Hi Anaïs, It's great to know that you are interested in the ALTO implementation! The ALTO implementation comes as a part of the Open Daylight platform. There are two ways to install it. 1. Download

Hello, my name is Anaïs, a few months ago I found out about the ALTO protocol. Then I started to search for server implementations and I found yours, which I think is by far the best I've seen. I

Thanks for the fix Robert.

'alto-resourcepool' vs. 'alto-resourcpool' https://git.opendaylight.org/gerrit/#/c/74722/ Bye, Robert

Hi guys. Any idea what this error is about? 01:00:20 [ERROR] Failed to execute goal org.opendaylight.yangtools:yang-maven-plugin:2.0.6.1:generate-sources (binding) on project

Attention alto-devs, Autorelease oxygen failed to build alto-service-model-networkmap from alto in build 373. Attached is a snippet of the error message related to the failure that we were able to

Hello, https://jira.opendaylight.org/browse/ODLPARENT-143 is tracking this for some time. Noone is working on it AFAICT. Regards, Robert

Hi Daniel and the autorelease team, I don't really know for sure. The module only contains a few source files and takes ~10 seconds to compile/test on my laptop. I remember there were quite a few such

Hello Kai, Thanks for the diagnosis. Is there anything that can be done to properly mitigate the failure? We have so many transient potential failures that we're almost certain to hit one on a given

Hi releng/autorelease team, As the report suggests, the failure is typically transient and should clear in the next run and no fix is required. Regards, Kai -- Kai Gao PhD Candidate at Institute of

Attention alto-devs, Autorelease oxygen failed to build odl-alto-resourcepool from alto in build 257. Attached is a snippet of the error message related to the failure that we were able to

Hi Dario, I think the document of openflowplugin has some typos. Obviously, "<ipv4-destination>200.71.9.5210</ipv4-destination>" is not a valid IP address. And from the YANG model [1], the value of

Hi, Kai. Thanks for your feedback. I'm getting the same error with "100.1.1.1/32" and other variations.I've been following all the steps

Hello Dario, It seems that it's the <ipv4-source>100.1.1.1</ipv4-source> tag. It requires an IPv4 prefix (from the regular expression) instead of an IPv4 address. You can try "100.1.1.1/32"

I’m working on a multicast project. It requieres simulation of data flow over an SDN controller. Unfortunately most controller simulators do not support multicast. I followed the instructions on

Seems like the environment problem. I think previously rechecking would help. -- Kai Gao PhD Candidate at Institute of Network Science and Cyberspace Department of Computer Science and

Attention alto-devs, Autorelease oxygen failed to build odl-alto-extension from alto in build 131. Attached is a snippet of the error message related to the failure that we were able to automatically

Hi Robert, That makes sense a lot. Already merged. Thanks! Regards, Kai -- Kai Gao PhD Candidate at Institute of Network Science and Cyberspace Department of Computer Science and Technology Tsinghua

Thanks. Would you consider https://git.opendaylight.org/gerrit/67447 to completely remove this dependency, so alto is not afflicted from this in future, please? Thanks, Robert

I have merged this patch. Best, Jensen